Tractor Talk Discussion Board |
Re: Can a 3-pt drawbar pull anything?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelvin on February 28, 2002 at 12:41:47 from (152.163.188.71):
In Reply to: Can a 3-pt drawbar pull anything? posted by Newbie on February 28, 2002 at 05:01:16:
My 2 cents: My uncle Henry used a drawbar in the 3-point on a Super 55 to pull his disk and his Athens Bog harrow, as well as trailers. My own experience is you do need stabilizers and you should have bracing to the third link mount on the tractor, so the drawbar can't rise much if stopping or backing up. I do recall pulling a leaf vacum with a drawbar once, When I backed up, the drawbar kinked the clevis hitch on the vacum and nearly tore it off. so watch your drawbar when turning and especially backing up.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|