|
Tractor Talk Discussion Board |
Re: square balers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by twopop on March 01, 2002 at 18:03:52 from (65.197.93.19):
In Reply to: square balers posted by Keiren on March 01, 2002 at 12:50:34:
the bales that are made in the far west,west of phoenix arizona,are 3 wire bales that usually measure 16 x23 x44 and weigh around 125 lbs.from phoenix on east,and i believe washington state the bales are 14 x 16 0r 16 x18 x44 and weigh up to 80 lbs.you can use around a 50 hp tractor with pto to make the smaller bales but,when your baling the larger bales at about 3 to 4 a minute you need a baler engine
Follow Ups:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
