|
Tractor Talk Discussion Board |
Re: Massey Fergerson 1135
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on March 17, 2002 at 06:53:06 from (216.196.13.135):
In Reply to: Massey Fergerson 1135 posted by Gary Osborne on March 17, 2002 at 05:35:18:
You have a valve that is stuck in the control valve and you will have to pull the top cover off and remove the valve . You just might get lucky and clean and polish the valve or you may have to buy a new one . There is one special tool that you will need to remove the valve but if you are good you can make it . Caution this is a finger pinchen job and you have to becareful of all linkage it is wise to take pictures of it so you can put it back together do not change any of the adjustments, some of the valves are spring loaded and when the spring is removed the valves must float free.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
