|
Tractor Talk Discussion Board |
8N Hupp overdrive removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Claude Mills on March 19, 2002 at 05:26:41 from (152.163.207.76):
Hello Forum,
I have a '47 8N. I removed a Hupp overdrive that
wasn't working properly. Then I put in a full
drive line from a 9N. Now the throwout bearing
will not move toward the clutch far enough to
disengage the clutch. I have the recommended
3/4inch top endplay in the pedal. The throwout
bearing moves 5/8 inch toward the clutch when
the pedal is depressed. I'm wondering if I have
to use a different shaft, that is, is the 9N shaft
is different from the 8N shaft. ?? Anyone know?
Claude Mills
1183 E Henri De Tonti
Springdale, Arkansas
479-361-2858
Follow Ups:
Home
| Forums
Today's Featured Article -
Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
