Tractor Talk Discussion Board |
Re: mowing with a model B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron on March 29, 2002 at 18:04:18 from (64.12.106.37):
In Reply to: mowing with a model B posted by Jason Smith on March 28, 2002 at 20:35:25:
You can get an after-market 3- point hitch for your JD "B"--providing you have hydrolics... Powertrol, that is... I would get that and use it....You will be much better off with the 3- point mounted mower, you can vary the height of cut from the seat, and it makes turning and backing a breeze.... The "B" is not too heavy in the front......you may want to use a mower that is not extremely heavy, OR hitch it so the 3- point only raises the front of the mower, and the rear stays down on ( a) rear wheel ( wheels )....
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|