Tractor Talk Discussion Board |
Re: Tractor flipping over
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on April 02, 2002 at 09:50:34 from (65.89.18.235):
In Reply to: Tractor flipping over posted by Stan on April 02, 2002 at 01:19:19:
I know from living in Northern California that some pretty hilly land is farmed for use as vineyards, citrus and olive groves and various other crops that thrive in that climate. Good judgement has to be used in the selection of wheel tractors and crawlers for use on these hills. Wheel tractors can be relatively safe if they have low profile, wide rear wheel tread/duals and the drawbar hitchpoint is positioned low as possible. Pulling from this low point helps keep the front end down and the tractor is safer pulling up hill than it would be going up the hill with no load because the draft pulls the front end down. Crawlers can be dangerous on hills if they are the narrow gauge type with narrow trackpads or grousers which makes them subject to sideways tipovers. Crawlers too are safer going uphill if they are pulling a load because the draft tends to pull the front end down and keeps them from rearing up and the front end coming over. The key thing is to keep the hitch point low as the drawbar adjustment will allow because this maximises the pull down on the front of the tractor. Weights mounted on the front help naturally, and are usually essential when using 3 point mounted implements to offset the weight of the implement when it is raised. Look at the equipment others are using on similar terrain and don't try to work hills that are steeper than what others are working, it won't be worth it. Roll over protection equipment and safety belt use are the approved safety devices along with equipment selection.
Follow Ups:
Home
| Forums
Today's Featured Article -
Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|