Tractor Talk Discussion Board |
Re: 1959 JOHN DEERE A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry S on April 02, 2002 at 15:00:55 from (63.71.59.98):
In Reply to: 1959 JOHN DEERE A posted by RICK STOOLMAN on April 01, 2002 at 20:30:44:
Rick, first off, you might have typed the wrong year in since A's weren't made in 59. I don't for sure know what broke for you but can tell you a couple ideas. The JD board can help you better than I can. If you can take your pto in and out of gear, see how it turns when out of gear. sometimes rocks break the teeth on that gear. It might be your first reduction gear that is a problem since you are trying to get in the clutch pulley area and that is where you are saying there is some problems which would effect both PTO and drive gears. I would recommend taking the pedestal off the top of the transmission and draining your transmission oil out then flashlight to look over what you have. should be at least a sign whether or not it is drive gear related or pto gear if you can get lucky enough to see to the bottom well. You can peek at the first reduction gearing by taking the clutch fork out that is in front of the first reduction gear/pulley housing held on by 4 bolts. that slides right out foreward and you can look there for signs of damage. if you need to take the pulley off, that will eventually need to happen anyhow. I would recommend telling the serial number to the nearest thousand at least when you post so responses fit your tractor more accurately. JD stopped making A's in the early 50's so the serial number will be how to tell what it actually is. Give plenty of detail about what moves and what doesn't so to eliminate wrong guesses. Good luck with your quest.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|