|
Tractor Talk Discussion Board |
Re: Re: Re: Re: J.B. Weld It, or Not ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ol Chief on April 07, 2002 at 19:14:06 from (24.162.28.111):
In Reply to: Re: Re: Re: J.B. Weld It, or Not ???? posted by Dell (WA) on April 06, 2002 at 21:37:10:
Iagree with Dell.Iwould never attempt to weld a crack without drilling both ends because most of the time the crack will run and you could chase the thing on and on.Also prefer a good brazed repair over J-B epoxy metal combo.If you go to a good weld shop ask to have the crack (DYE Checked).This will tell you where the end of the crack really is.Then drill.SPOT CHECK is trade name of the DYE System .all welding supply co. stock the stuff.If you did not see the crack until you cleaned the piece maybe your supplier also missed it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
