|
Tractor Talk Discussion Board |
Re: Shop Floor - Need opinions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on April 09, 2002 at 09:30:42 from (38.192.251.39):
In Reply to: Shop Floor - Need opinions posted by Jason on April 09, 2002 at 04:52:44:
Jason -
I built a 30x60 shop and poured concrete. I debated on the gravel for some time. I decided on concrete for the following reasons: 1. Once done it's done!
2. Two pours more expensive
3. Two pours more effort to get & keep level
4. Work on my own rigs, creeper won't roll on rock
5. Less time to clean, hose down and squeegee I have also included a link to some random pics of my shop in various stages. All that is left is adding the front and rear drive thru doors. After that I will be adding 30' wide lean the entire length of shop and putting down gravel. This will be for tractor & implement storage.
HTH
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
