Tractor Talk Discussion Board |
Re: I'm trying to learn to haul my tractor safely - have a question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rhudson on April 11, 2002 at 21:05:25 from (63.81.99.12):
In Reply to: I'm trying to learn to haul my tractor safely - have a question. posted by Bill Oakes on April 11, 2002 at 18:52:30:
apply straps at points of support. in other words near the front axles, near the rear axles. this limits stress on the tractor itself. straps (or chains) should be attached to the lower sides of the trailer upward to tractor. this will hold tractor down and also limit side to side movement. if load balance perments, tractor should rest against trailer headboard and be secured to headboard with straps, chock blocks (secured) behind rear wheels and straps to rear of trailer(all this limits backward travel due to accereration and forward movement due to panic stops). now double up on all four straps for safety "two is one, one is nothing" i think thats a military demolitions saying. secure gas tank/rad caps/toolbox lids/hoods any anything else that might work/bounce/break free. safety tie or tape chain binders down, if using straps use strain reliefs (Northern for about $2.00 each) at corners and edges to keep the straps from being damaged. i have switched from chains to straps for ease of use. study load in rear view mirrors and take note of any movement during trip. stop at first store (within about 3 miles of load pickup) check the load and all straps, buy cold drink. continue to stop and check load about every two hours. notice any strange sounds and notice the reactions and driving habits of cars around you (They may be seeing something about your rig and load that you don't see) I know this sounds excessive ( i have a friend that secures nothing and has not had a problem), but i have an active imagination and i don't want to have to worry about anything i don't have too while navigating in foreign territory.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|