|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Case Steam Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allen on April 12, 2002 at 15:24:47 from (207.44.55.92):
In Reply to: Re: Re: Re: Case Steam Tractor posted by Bill Jones on April 12, 2002 at 10:18:03:
I know what you are saying, but its not the whole story. It was the time that the big custom threshing crews were on their out. Since money was tight, more farmers chose to, either on their own or in a small co-op, purchase a smaller machine and yes with a gas tractor because it was cheaper...rather than pay the custom man.
A well taken care of boiler was designed to last 10-20 years of "normal' service. An engine that had reached the end of its life cycle was often replaced with a gas tractor because modern=good to many minds at that time. Also, as the depression was looming, and the custom man was losing money to those smaller rigs, the labor savings sounded REAL good to the threshing boss. In hobby use (once or twice a year) the life expectancy is greatly lengthened, not shortened...provided it recieved proper care. The biggest cause of erosion in hobby boilers is crud, stuff that isn't cleaned off, ashes not cleaned out, soot left in the smokebox, sediment in the boiler, etc. Since there is usually little hurry the fire is not "Pushed" with blower, etc, so temperature changes are MUCH more gradual, LESSENING thermal stress. BTW, I've been running engines for 25 years, learned from some of the old timers who ran then (traction AND rail) in "the old days", and from an insurance boiler inspector. I've got my ASME section IX weld certs and have BUILT small steel boilers. So I guess that makes me just another dumb yokel who doan know nuthin.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
