|
Tractor Talk Discussion Board |
Re: Distributor MELTDOWN !!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Time on April 22, 2002 at 07:08:17 from (216.109.205.98):
In Reply to: Distributor MELTDOWN !!!! posted by THEO on April 21, 2002 at 20:13:52:
wild times dude.
left the key on, energized the feild winding in the generator, poor thing was trying to start that big engine, and couldnt, bet its baked to a delicate crunch inside. sounds like no ballast resistor on the points wiring, the points probably glowed like a lightbulb. and you can bet those power leads smoked all the way from the battery to the switch, and back to the regulator, and coil, so you need a pretty large pile of new parts/cash to ride on that heifer again. lets see..
voltage regulator, generator, wiring harness, distributor cap, rotor, spacer plate, points, condensor, ballast resistor, points wire case insulator, possible ignition switch, in all i can only say..
Glad it wasnt my tractor. sorry
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
