Tractor Talk Discussion Board |
Re: Parked 7 Years Engine Corrosion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on April 26, 2002 at 03:16:43 from (207.173.149.131):
In Reply to: Parked 7 Years Engine Corrosion posted by Mick on April 24, 2002 at 14:09:23:
Hi Mick, Since you already started the engine for 2 minutes, I would think you built up oil pressure so that shouldn't be a problem. I would check the oil level, anti-freeze color and level, add fresh gas to the tank, crank it over and watch for oil pressure. If it's got fair oil pressure, above 20psi, then I would run at idle until hot but keeping a close eye on all the gauges and do some walk arounds. If nothing shows up after a hot idle run, then I would change the oil/filter and coolant. Start it again watching all the gauges and run until a hot idle. If all was hunky dory, I'd take it for a drive and build up some rpm. Any problems should show up fairly fast. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|