Tractor Talk Discussion Board |
Re: Re: Re: What's a Puller?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Thats a funny joke on April 28, 2002 at 07:54:39 from (205.188.201.146):
In Reply to: Re: Re: What's a Puller? posted by Oh yes it is on April 27, 2002 at 21:36:17:
What do you know about pulling, burns? All you do is talk about it. You never stroked a motor. You never bored one more than 1/8 over. The biggest improvement you have done is put in a dry air filter. Oh you might have put a different cam in, but that was only you buying what some one else told you to do. Talk, talk, talk is all you every do. Those that can, do. Those that can't, teach.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|