Tractor Talk Discussion Board |
Re: Front wheel assist.....Four wheel drive
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on May 05, 2002 at 21:25:07 from (66.133.133.178):
In Reply to: Front wheel assist.....Four wheel drive posted by Jerry on May 04, 2002 at 19:38:43:
Broken wrench is right. Oliver had both at the same time. "Mechanical" Four Wheel Drive and "Power assist" Four Wheel Drive. The machanical four wheel drive put power to the front wheels useing a drive shaft. Power assist four wheel drive used hydraulic motors on each front wheel. In other words , the power assist four wheel drive was not really a true four wheel drive. The front wheels just kind of helped (assisted) the rear wheels. I read that Oliver had problems with the power assist four wheel drive. With out looking it up , I belive the hydralic motors got hot and failed.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|