Tractor Talk Discussion Board |
Re: Do you fellas do tractor mowing for hire?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in Maryland on May 08, 2002 at 11:31:09 from (66.56.220.94):
In Reply to: Do you fellas do tractor mowing for hire? posted by lc on May 07, 2002 at 13:13:01:
I do it some, just kinda as a little side thing. As others have said, it depends on the terrain and what you're cutting. If it's just grass, say 5 acres, I charge $50 to show up and about $35 each hour after the first hour. Never had anyone complain. I have also done a spot that was only 1 1/2 acres, but was small locust trees w/big thorns, REAL THICK, about as tall as the top of the roll bar on the tractor. That time I was using a case IH 385 and 6' bushhog. The guy had bought the property and had no idea if there were stumps or what. I told him flat out, $275, and if I got a flat tire as the result of a thorn, he agreed to pay half of the repair, whether it be front or rear. Actually took quite a while to get it knocked down and looking nice. On the other side of it, I have done some bushhogging for a fella that buys land, clears it, then turns into housing subdivisions. The land has been cleared, but weeds will grow up in the lots if it takes a while before they are built. I go in before they start, he pays me $100 per lot. They range anywhere from 1-3 acres. I'm not on a contract or anything, he is a friend of my fathers and my brothers and I do it for him, and that is what he offered to pay me. I lost money on the last one I did for him. One bushhog a u-joint broke. Went and got the other one, and in the weeds the blades hit a "tooth" off the bucket of an excavator that had broke off. Broke 5" off the end of my blade. By the time I got parts and things fixed and had run over there 3 times, I think I lost money on the deal. Don't be afraid to charge a decent price if you do a really good job.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|