Tractor Talk Discussion Board |
Re: 300U Exhaust Pipe
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron_NY on May 24, 2002 at 06:22:18 from (172.161.182.28):
In Reply to: 300U Exhaust Pipe posted by farmall300u on May 23, 2002 at 19:08:56:
Just in case I am not the last person on the planet to discover "flex pipe" for exhaust systems, I thought I would bring this stuff to your attention. The flex part allows it to make curves. It is generally used for "temporary" repairs, although it will outlast the standard exhaust pipe. It is available in many diameters - 2" flex pipe goes OVER 2" exhaust pipe, and is held with standard exhaust clamps. It is sold in most auto parts stores, and is cheap, approximately $3/ft. The store will cut and sell you the length you need.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|