Tractor Talk Discussion Board |
Re: Seamon Tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hal/WA on May 27, 2002 at 13:21:19 from (208.8.194.21):
In Reply to: Seamon Tractor? posted by Bob M (w/pix) on May 26, 2002 at 06:49:19:
It sure looks like the manufacturer used a lot of off the shelf truck parts from the era--the engine, probably the transmission, the front axle and leaf spring suspension. There probably was a choice of a number of engines that would fit the chassis. I am not familiar with that rear end, but outwardly,it is about the size as medium trucks had then. Some of the posters mention rototillers on these tractors. I did not see a PTO shaft in the photos. Is the PTO handled by an add-on case bolted to the side of the transmission case? To do rototilling, a tractor has to move very slowly. How is the slow speed acheived, through transmission gearing, or are the rear gears way steep, like 10 to 1? Your tractor, though done much more professionally, reminds me of a homemade tractor some friends made out of a 40's International 1.5 or 2 ton truck. The front end was intact with the hood covering the original engine and front axle. The cab, which had been ruined in a roll over was cut off and the frame was shortened to long tractor length and the truck rear end with duals was mounted solid to the frame. To get it to go slow enough for tractor work, a second 4 speed transmission was mounted just behind the original 4 speed and a very short driveshaft mounted to the rear end. A huge block of concrete had been cast above the rear end for traction and they always left the duals chained up. In compound in both transmissions, the machine would go extremely slow, and as we found, in high in both transmissions, it was scary (and dangerously) fast! The brakes left a lot to be desired though. We had a lot of fun with it and they did their heavy pulling with it for years.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|