|
Tractor Talk Discussion Board |
Re: 8N carb rebuild question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by polk crawler on June 08, 2002 at 07:01:23 from (158.104.97.28):
In Reply to: 8N carb rebuild question. posted by Whooly on June 07, 2002 at 20:40:29:
If you look under ARTICLES menu LH side of this page there is a detailed article on carb rebuilds including pictures. While my OC3 carb was different I bought the correct kit, followed article instructions and managed the rebuild. You may have to get a deep socket to reach one jet deep inside the body of the carb. Once you get carb dissembled, put it in cleaner as instructed...a little costly but really gets rid of any gunk accumulation; blow out well with air and then put it back together. Good luck. PC
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
