Tractor Talk Discussion Board |
Re: Dodge Cummins w/ auto for pulling my tractor around???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on July 25, 2002 at 10:41:22 from (63.20.220.148):
In Reply to: Dodge Cummins w/ auto for pulling my tractor around??? posted by MaybeDodge on July 25, 2002 at 07:26:20:
My torque converter failed & trashed my transmission while pulling a trailer in Kentucky. It is a 96 4wd 1/2 ton Dodge with the 360 magnum. It had 94,000 miles at the time. Had it fixed at Kentucky Transmission, a fairly large shop. Cost over $2,000 counting the rental car. Most of what was in his shop were Dodges 1/2, 3/4 and 1 ton that had been plowing snow the previous week. He said Dodge had a lot of trouble ever since they replaced the old 727 trans with the 4 speed auto. I am going to replace this truck with a 1 ton diesel 4wd crew cab with a MANUAL TRANS (when I can find one I like)
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|