Tractor Talk Discussion Board |
Re: Field Marsall tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew from Aust. on August 01, 2002 at 23:42:59 from (203.108.191.40):
In Reply to: Field Marsall tractor posted by Don E. Foster on July 30, 2002 at 16:24:28:
Hello Don, I have a Field Marshall also. They are either crank start or cartridge (12 gauge like shot gun cartidges but with a special mix that gives a gaseous charge - if you used normal shotgun cartridges you'd do real damage!) I only start mine with the crank handle. Every time you start them you have to put a lit paper (basically just a piece of blotting paper which has been treated with salt petre to allow it to smoulder)in the holder in the head. This will help combustion like a modern glow plug and prevent it from kicking back etc. Engage the decompressor which runs on the screw thread cut around the outside of the flywheel. You don't need to remove the paper as when it first fires it will burn it and exhaust the ashes. I would think that a Field Marshall would be pretty collectible over there. They are 40 HP at the belt. They have an incredible amount of grunt down low which is useful when you are shunting things around in the shed etc. Over here in Australia they seem to be pretty common and not nearly as collectible or popular as Lanz Bulldogs which are similar but the German version. I wouldn't swap my Marshall for anything! Anyway I think your JD would be a nice machine also. I have a 1938 model D. I guess $10 000 is a lot of money but you could buy a new car for the same amount today and it wouldn't be worth anything near that in a couple of years! Regards Andrew
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|