Tractor Talk Discussion Board |
Re: Hauling tractors
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve - IN on August 27, 2002 at 18:20:05 from (12.222.132.139):
In Reply to: Hauling tractors posted by David UK on August 27, 2002 at 16:17:41:
Nobody wants to do the conversion, I guess. 2.55 meters wide is about 100 inches. 7 meters length is about 23 feet. Seems to me that most full size US tractors made after about '70 or '75 couldn't move along the roads in Scotland. And there are a whole lot of trailers here longer than 23 feet. Your redcoats could have done us a favor in 1775. When they went to Lexington and Concord to confiscate muskets, they could have taken Paul Revere's horse while they were at it. Taking the muskets gave us the 2nd Amendment -- keep and bear firearms. If they'd taken the horse we would have had an amendment to guarantee free and unfettered transport. The idea that a drivers license is a privilege and you need a security check now - least in this state - wouldn't be around. I guess the redcoats and Hanovers didn't do you any favors after Culloden either, so I shouldn't be barking up your tree. They tax your gasoline and Diesel unmercifully and you can't run anything that will cover a lot of ground quickly. Seems they want you to just stay put and shut up except when they send you to colonize Northern Ireland or off to join the BlackWatch. I guess we should say thanks for sending us the likes of Andrew Carnegie and a lot of other Scots that came this way -- my wife had a Mc type Scots name, so I gotta watch the P's and Q's. Anyway, in this state, max width for free is 102 inches (2.59m). 102 to to 144" (3.65m) gets you wacked with more licensing fees. Above 144 inches requires a special permit. A single vehicle can be up to than 36 feet (10.97m) in length with no special tax. A "truck / trailer combination " can go up to 53 feet (16.15m) in length. Other states may vary slightly. Hope that answers your question, and you'll take or leave the opinions as you will. Take care over there and enjoy that Scotch whiskey we pay so dearly for over here! Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|