Tractor Talk Discussion Board |
Re: H tractor block
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on September 03, 2002 at 20:11:44 from (128.242.4.59):
In Reply to: H tractor block posted by lucky on August 26, 2002 at 10:28:07:
Sure sounds like you are in a fix. There is so many options you can do. The right guy might be able to fix it without a hole lot of expense. I know a talented welder/mechanic that has been known to fix stuff like that. But if you aren't attached to the tractor and it is going to run into alot of expense, you would probably be better off getting an entire engine from salvage yard rather than just a block. But there again, you would halve to watch expense becuase if you can buy another running H for less money, that would be a better way to go. And then you would have the H you got now to use for future parts. You will just have to check around and see which is the cheapest way to go.
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|