Tractor Talk Discussion Board |
Re: Things of Marginal Value
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on September 06, 2002 at 06:37:08 from (206.106.139.74):
In Reply to: Things of Marginal Value posted by moonlite on September 06, 2002 at 04:16:32:
Here are my impressions of the "unnecessary" parts you describe, and this is just my opinion. Brake pedal latch - a good safety feature. It should be used whenever you're operating the tractor at high speeds - just like it says in the manual. It's easy to make sure you hit both pedals when you're in complete control of the tractor, but in an emergency situation, it's not hard to only hit one brake pedal, which can result in an upset tractor, injury or even death -my best friend was killed in a similar situation. Differential lock - Steve hit the nail on the head, applying a brake to a fast spinning tire is a good way to brake parts, not to mention that fact that you'll never be able to modulate the brakes to control slippage as well as the diff lock can. The diff lock also makes the tractor more efficient when used in low traction situations. The bumper _ I don't know - haven't seen many tractors with bumpers. Vinyl seat - Steve called that one well, also. Foot throttle - very handy in situations where minute speed changes are needed. Case in point - we use a JD 8450 on our grain cart. When unloading a combine on the go, I throttle the hand throttle clear back and use the foot throttle to match the varying speeds of the combine, which is much easier than using the hand throttle. It also allows me to focus my full attention on the unloading auger.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|