Tractor Talk Discussion Board |
Re: Pickup truck fuel tank.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JohnnyB on September 09, 2002 at 14:10:37 from (205.188.209.109):
In Reply to: Pickup truck fuel tank. posted by John on September 08, 2002 at 19:03:07:
John, I took a round 50 gallon tank that was a gas tank off an old 2 ton truck and bolted it on a wood pallet. Two people can easily put it in the bed of my truck empty but I unload it when full with my forklift. Obviously you'd have to have a forklift or a front end loader would do but my local fuel distributor won't come out for less than 200 gallons and i only use about 300 gallons a year and would hate to have it permantly mounted on the truck, most tanks are pretty thin metal but seem to hold up fine. Also it don't take too many gallons of fuel to be quite heavy.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|