Tractor Talk Discussion Board |
Re: hydrualic pump cavitates
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Clark on September 12, 2002 at 18:51:24 from (24.154.153.13):
In Reply to: hydrualic pump cavitates posted by mike on September 09, 2002 at 22:07:32:
It's very likely that the cumulative vibration and stress caused the gear to break even after you removed the screen. Also after you removed the screen a small particle might have caused the breakage (your talking about micron clearances). Either way you have to find the root cause of your problem or you'll just break another pump. A suction "screen" should not cause cavitation in a well designed system unless their is contamination or the viscosity of the oil is wrong. About engine speed, it depends on the application, but as a for instance the early Case skid loaders (the ones Case designed, after the original "Uni-Loaders") particularly the 1830's were only to be ran at idle or full throttle because the charge section of the pump had a different performance curve than the the piston (driving) section. Running half speed would cook a pump quicker than anything. Don't know if this helps but maybe it will give you some food for thought.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|