Tractor Talk Discussion Board |
Re: to-30 sleeves need help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred OH on September 13, 2002 at 04:48:49 from (208.32.116.15):
In Reply to: to-30 sleeves need help posted by jim (ky) on September 11, 2002 at 07:14:57:
Jim, the kits that I've seen/used had 3 o-rings per sleeve and they fit snug so as not to shear when installing. I think I used vaseline on them to help them on the way in and a can of stopleak in the radiator...just in case. If you can't get the right amount of o-rings...I would put them in the top and bottom grooves as the bottom groove would be destroyed if you left it open to the coolant. I guess the third o-ring is there to make double sure of a good seal against coolant leakage. L8R....Fred OH
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|