Tractor Talk Discussion Board |
Re: Rough runnig 8N
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on September 13, 2002 at 09:43:04 from (165.234.131.184):
In Reply to: Rough runnig 8N posted by Paul on September 12, 2002 at 18:24:36:
The problem with setting the idle that you are describing I think might be due to the tachometer. If the tach is set for an 8 cylinder engine (or even a 6) it will read slower on a 4 cylinder. So if your tach is made for an 8 cylinder engine it would actually be reading 1/2 of what your engine is actually running. If the tach is set for a 6 cylinder your reading would be 2/3 lower than actual. If you are reading 400 RPMS on your tach and it is set for 8 cyls then your tractor is actually running 800 RPMS. Hope that makes sense for ya. Steven
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|