Tractor Talk Discussion Board |
Re: What engines were in WWII tanks ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on September 22, 2002 at 11:06:23 from (65.165.154.8):
In Reply to: What engines were in WWII tanks ? posted by Just Wondering on September 21, 2002 at 07:28:59:
Some of the comments below are obviously from those much younger than myself-which is most everybody. The Chevrolet V8 was introduced as a 265 in 1955 and enlarged to 283 in 1957- not available during WWII which ended in 1945. The Cadillac V8 was a flathead till 1948. The Cadillac had the exhaust coming out the top of the engine-thus the carburetor sat between 2 exhaust pipes. That engine was considered to be an excellent one. The Packard 8 was a straight 8. The USA was caught very unprepared for the scope of WWII and the use of all these adaptations from civilian engines was necessary to meet the volume demands. Packard also built some Rolls-Royce Merlin V12 aircraft engines. I think that a strong existing military lessens the likelihood of an attack- for the record, I easily recall when my Father was drafted during WWII. Near the end, the age of some draftees was approaching 40.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|