Tractor Talk Discussion Board |
Re: L-260 KUBOTA
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi on September 28, 2002 at 15:27:38 from (208.224.10.253):
In Reply to: L-260 KUBOTA posted by Melvin on September 28, 2002 at 13:42:34:
If the generator requires 24 PTO HP, then it must be about a 12,000 watt? (12kw) I think what you are going to find is, it takes a lot more engine power to run the higher PTO speeds, (because of the internal gearing to speed up the PTO) and also those little engines have to spin fairly fast to make much HP, and torque with out lugging. Another thing, when your engine is turning slower, the water and oil pumps are running slower too. All of this adds up to, i wouldn't do it. Only exception is, if you were only going to draw a very light load from the genset, (500watts?) for a "short" peroid of time. I don't think that's what you had in mind. Something else to keep in mind. You should NOT pull more than 80% full load (HP) fron your PTO for extended lengths of time. So, if you want to pull 12kw out of a PTO gen. set for continual service, you need about 30 PTO HP to start with. It's no big deal to pull full power out of the PTO for a few minutes to start bigger electric motors, or when running a welder off the gen. set, so don't worry about that hurting your tractor. BTW, i also have a Kubota with multi speed PTO, and a 15kw (18kw surge) PTO generator, and i wouldn't run mine the way you described. With my Kubota, you select the higher speed on the PTO, then set the RPM to the 540 setting. Doesn't your generator have a volt meter to tell you when you have the RPM right??? That's what you should be going by. Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|