Tractor Talk Discussion Board |
Re: Woods 9000 Backhoe
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by geok on September 29, 2002 at 04:48:54 from (63.104.132.224):
In Reply to: Woods 9000 Backhoe posted by Grant Hill on September 28, 2002 at 18:54:01:
Look for leaks. If machine is mounted operate it. Extend unit all the way out just a few inches off ground and notice if it leaks off. Swing unit from side to side to check for worn and loose pins. The bucket is too wide for most applications. Would not mount unit on 3 point unless you are certain your tractor can handle it. I have seen transmissions cracked in two and 3 point hitches destroyed with these units. It is better to have a it mounted to a sub frame.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor: Part 2 - by Anthony West. In February 1953 production of the ETC T.V.O engine started, ready for the March 1953 press announcements. The new TVO engine had a number of improvements which resulted in a 10 per cent more power (43bhp as against 38 bhp on the earlier engine) and 10 per cent more fuel economy. Some of the improvements are listed below: Redesigned combustion chamber, improved spark plugs and positioning, plug size 14mm(earlier size 18mm).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|