Tractor Talk Discussion Board |
Re: Re: Re: Re: What does CRP stand for
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on October 07, 2002 at 08:56:32 from (206.106.139.74):
In Reply to: Re: Re: Re: What does CRP stand for posted by Dave_Id on October 06, 2002 at 16:45:10:
I agree totally that non-farmers should not be collecting CRP payments. However, ground that is eligible for CRP is a very small percentage of the total farm ground in the U.S., and even a smaller percentage is actually enrolled in the program. So you can't tell me that putting that ground into production is going to keep us from importing food from other countries. There are also situations where CRP is the best option for ground. My grandpa has an 80 acre piece of land that is approximately half CRP. It is very steep and highly erodible. It required yearly upkeep to repair ditches, waterways and terraces, as well as being a general nuisance to farm. Since there is a lack of natural water on it and no place to put a pond, pasturing it was out of the question. So, he put it in the program. And since he and my uncle farm about 1500 acres of row-crops, have a few hundred acres of pasture and hay ground, 250 cows and a 150 sow farrow-to-finish hog operation, it's a safe bet that the 40 acres of CRP aren't putting the food on the table. I'm all for closing our borders to all trade with foreign nations and letting them go hungry. America can certainly provide everything it's citizens need, regardless of what it is. Maybe then we could sort the farm situation out to the point where American farmers feed Americans first, and we sell the remainder at prices we set. But as long as we feel the need to give our grain away so we can buy from other countries, that isn't going to happen.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|