Tractor Talk Discussion Board |
Re: Re: Re: Re: buy an ox?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy on October 12, 2002 at 15:50:34 from (206.215.212.243):
In Reply to: Re: Re: Re: buy an ox? posted by sod on October 12, 2002 at 15:26:43:
roll-pin? shaft? of..... Well I now own a useless $32 timing light, because the timing marks on this tractor's flywheel have apparently worn off. The flywheel is smooth except for some dirt--the timing hole cover was off. So I turned the distributor, in two successive increments, about a total of 10-15 degrees as you suggested, Sod, and that brought the tractor to nearly full power under load. I can work with it now, but it still seems a bit underpowered. Anyone know of a way to hit the timing on spec without marks? It's supposed to be 4 degrees before top dead center at 450 rpm. I don't have a working tachometer, but that may be academic. It no longer clanks or clicks. Thanks Sod Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|