Tractor Talk Discussion Board |
Re: steam tractor piping plans
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allen on November 13, 2002 at 20:13:51 from (66.152.128.188):
In Reply to: steam tractor piping plans posted by mike patrick on November 13, 2002 at 17:34:48:
I don't know of any plans-- most guys seem to sorta just make do basing an educted guess upon what others have done, and what hardware is in the way. The only 4 really critical things that I can think of is 1)to get the nut on the bottom of the water glass at least 3" above the crown sheet. 2) pipe the safety directly to the dome on its own pipe. 3) make sure you install the check vales the right way. and 4) make sure there are absolutely NO air leaks on the water supply side of the injectors or they won't work You could try contacting Case Historical, or Frick or Russell collector's clubs, if it is one of those for proper routing. Or cruise the various club websites for similar engines
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|