Tractor Talk Discussion Board |
Re: Gas Tank Inside Cleaner/Sealers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad--IN on December 16, 2002 at 17:34:35 from (65.119.162.146):
In Reply to: Gas Tank Inside Cleaner/Sealers posted by Jeff on December 15, 2002 at 17:48:45:
Never have been a fan of putting rocks in a gas tank. I have used large ball bearings or chain links. Rocks have a tendency to break and become more problems later. I usually count how many pieces I put in and make sure I get the same number back out. Then the sealer I purchased at the local NAPA. They even had two or three choices. Can had a picture of a tractor and a truck, so it should work on both (ha). Used mine on a '67 grain truck, process was pour sealer in, roll all around, drain, repeat 24 hours later, then cure 24 hours. Four years running now without additional problem. GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|