|
Tractor Talk Discussion Board |
Re: Re: Hydraulic driven PTO ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ben in KY on January 08, 2003 at 16:14:29 from (192.76.82.90):
In Reply to: Re: Hydraulic driven PTO ? posted by Bob on January 08, 2003 at 14:30:48:
Thanks Bob. I will appreciate any information you can give. The hydraulic motor is my big question. I will put a pump on big enough to drive it. I will need about 20 hp output or better.
The hydraulic motor part is my big question. The motor unit will have a dedicated pump for maximum power and speed control. I am just not sure if I can get the power I need out of a hydraulic motor. I can gear down the output of the pump if necessary to get the torque out at PTO speeds.
I am willing to experiment, but don't want to invest money in parts for a project if I cannot make it work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
