Tractor Talk Discussion Board |
Re: What is an induction motor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on January 20, 2003 at 16:06:46 from (65.165.153.61):
In Reply to: What is an induction motor posted by Andy on January 19, 2003 at 09:26:38:
Capacitor start motors are induction motors. Induction motors are the most durable type. The armature, rotor if you prefer, has no electrical connections to it. The currents flowing in the rotor are "induced" by the magnetic field of the "stator" or the stationary field windings. Three phase motors are usually induction motors also. Series motors have terrific starting torque, but brush life is typically about 200 hours. 200 hours is lots of use for a portable drill or router, but not much for an industrial air compressor- the compressor will use an induction motor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|