Tractor Talk Discussion Board |
Re: Continental Engine.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on January 30, 2003 at 11:04:21 from (64.12.96.236):
In Reply to: Continental Engine. posted by Mechoman on January 30, 2003 at 06:14:15:
It is quite possible the parts will go together. If there is going to be a problem it will be in the clutch and pilot bearing or the input shaft to your gear box. The engines were good engines. Federal Mogul makes quite a few parts, and is available from most part stores. If you want to shop around get part numbers from NAPA and check by part number with places like Advance Autoparts or the others, they can't seem to look up parts for anything other than cars anf light trucks, and have to start with the year of manufacture first, but if you come in with a part number they cna look it up, and you might find cheaper parts. The parts are very expensive. Continental quit making industrial engines in either the 1970's or 1980's, and continued making aircraft engines which they still make.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|