|
Tractor Talk Discussion Board |
Re: Re: an engine question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on February 02, 2003 at 15:32:39 from (195.93.34.10):
In Reply to: Re: an engine question posted by Bill Hires on February 02, 2003 at 14:39:52:
His friend might just be talking about cycles and not revolutions. One revolution could equates to two 'strokes' per piston, so he could mean idle rpm/60 and then *2*number of cylinders. There again, if you consider 4 strokes as one complete cycle, the you should divide by 2 instead.
Kinda lotta possible answers to this one - now what exactly was this guy actually referring to?
Also try comparing very old slow running single cylinder machines with todays modern multi cylinder engines and ball game is completely different
Regards, RAB
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
