Tractor Talk Discussion Board |
Re: Mounting a ball in a pickup
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on February 15, 2003 at 22:21:03 from (65.57.36.12):
In Reply to: Mounting a ball in a pickup posted by Charles W. Story on February 15, 2003 at 17:24:13:
Hi Charles, I've read on several mfg websites that theres 1% loaded front axle weight difference from 4" "behind " axle center to 4" in front of axle center. So it's really where you want it. I have mine on axle center line. You do realize that the 3/4" plate will deflect about 1/2" or more depending on pin weight? I did a series of test last month on using 3/4" plate, added 1/4"x2"x2" tube on both edges of the 3/4" plate and still deflected 1/4" at about 3000lbs. I used a 2ton hydraulic jack with a chain for simulated pin weight. What this does is pulls on your frame rails every time it deflects. I'm working with a 2K2 F350, DRW. I redesigned and went to a 3/8" plate pryamid design 12" high. Theres no deflection with this design. I'm "inbed" so I'm not wanting to crush the bed SM nor flex my frame rails. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|