Tractor Talk Discussion Board |
Re: Old combine Hydrolics 101
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DHuth2 on February 17, 2003 at 21:07:38 from (198.81.19.26):
In Reply to: Old combine Hydrolics 101 posted by Arnie on February 14, 2003 at 21:17:22:
Sorry to see no one has been able to help ypu out....I suspect that your system was supplying a certain amount of oil to the steering system.This is called a priority valve. It will send a set gpm of oil to steering no matter what the other demand on the pump is. It may require this flow to be sensed before it will allow oil out to your hyd control valve. When you capped it it sounds as if you removed the relief valve from the circuit....result blown hose......relief may be in steering cylinder. Not sure as I have not worked on this system but some of it sounds familiar.As for the valve.....not sure...need to see a diagram...I now that not much help but hated to see you not get a response....goodluck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|