Tractor Talk Discussion Board |
Re: Please Help I.D. Tractor ??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on March 02, 2003 at 12:30:58 from (128.242.4.59):
In Reply to: Please Help I.D. Tractor ?? posted by Todd on March 01, 2003 at 19:13:54:
The cub was wide front, right side seat, and Farmalls smallest of letter series. The A was next size bigger, wide front, right side seat and available in high clear. The B was basically the same as the non high clear A but with narrow front end and available in the narrow tread. The C was next size bigger and the driver was seated in center, typically narrow front but wide front may have been an option. The C had considerably taller rear wheel's, I think 36" rear tires. The H was bigger yet. It had engine side frame rails and in-line steering shafts over the engine unlike the smaller models. It was typically narrow front with 38" rear tires. Wide front and high clear were options. I believe the high clear had drop axels. The M was bigger but basically just larger in scale to the H. Wide front and high clear were options on the M too. All of the letter series tractors (except cub I think) were improved into the super series in later production years. The cub I think was the only tractor that remained in production for a few more years when Farmall switched to the newer number series tractors. If this tractor you are talking about is a letter series farmall, this should help you identify it. You may also want to check out some of the photos under "tractor photos" on this forum. It is on the left side of screen under Gallery. Click on it and then Farmall. Then you can see some actual pictures to compare to.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|