|
Tractor Talk Discussion Board |
Re: Re: Re: Re: BELARUS TRACTOR
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jack on March 04, 2003 at 18:08:12 from (66.82.9.33):
In Reply to: Re: Re: Re: BELARUS TRACTOR posted by M Higginson on November 25, 1999 at 11:12:10:
I have a Belarus 250A and the finger on the clutch look worn. They are only about 1/8" thick
on the end where the throw out bearing touches
them. One deal said it looks like your throw
out is froze. The clutch has been working ok
till today. I bought the tractor used and it
has 220 hrs on it. Looks like I might have to
split it and replace some stuff.
What is the beat way to split and support the
tractor halfs and move them apart?
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
