Tractor Talk Discussion Board |
Re: wesson oil??????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on April 12, 2003 at 06:25:33 from (65.56.249.192):
In Reply to: wesson oil?????? posted by carl on April 10, 2003 at 16:07:50:
Hi Carl, Veggie oils have a very good lubicating value. They can even be used for engine oil but theres not very much posted info for this application. I've read one University study that 2% veggie oil added to #1D fuel oil equals the lube value of #2D ultra-low sulfur diesel fuel. I've been looking into using veggie oils for fuel oil replacing my #2D usage. Rapeseed oil seams to be a better quality of veggie oil than soy based for fuel oil, slightly more btu's with rapeseed. They have found that older rubber hose will deteriate when using B20 (20% veggie oil/80% #2D) so if using in older hydraulic hose I would expect you would need to replace the hoses very shortly. The new R100 hose is rated for veggie oil use. To use raw rapeseed oil as a fuel oil, it needs to be thined as it has 20 times the viscoity of #2D at 70*. At 45* a typical diesel will not start on B100 without being prewarmed. Alot of guys are starting there engines on #2D then switch over too B100 when warm using a coolant heat exchanger. 25% raw veggie oil can be used without any problems to the injection system and without any modifications. Another University study. Any raw veggie oil is not biodiesel as it still contains glycerin. B100, 100% biodiesel, is veggie oil with the glycerin removed. Glycerin is a heavy type wax of veggie oils. Here in Arizona I use 10w30 motor oil as a hydraulic oil. My pump is worn along with our summer abiment temps are high and thins the standard hydraulic oil too much. I've got about a 100 hours on my backhoe using motor oil without any problems. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|