Tractor Talk Discussion Board |
Re: original tire tread for M model
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on April 17, 2003 at 21:22:15 from (65.237.15.171):
In Reply to: original tire tread for M model posted by Deryl on April 17, 2003 at 14:42:13:
If you have a 13.6x38 tire on your tractor, the rim should measure 12 inches between the edges of the rim- not 13 inches. The tire measurement system changed in the 1960s, and the new size marking refers to the CROSS-SECTIONAL width of the tire, rather than the rim width, which is smaller. So a tire of 12 width became 13.6 inches wide by the rim diameter. Cross-sectional width refers to the widest part of the tire (bulge in the middle) rather than the width of the rim, or the width of the tread.
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|