Tractor Talk Discussion Board |
wagner loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by stan lalonde on April 24, 2003 at 11:17:25 from (170.215.220.81):
Hi, I have just completed rebuilding a wagner loader, actually I had it rebuilt. I put it on the tractor yesterday and found that one of the cylinders was broken off at the bottom inside. The other cylinder seems to be ok , just needs cleaning up and repacking, I hope. I think that the control needs to be rebuilt, also. I have been on the computer all morning and can't seem to find where I could get a cylinder or two for the loader. The loader is a wagner loader model W1 IC Serial no 376. I was wondering if any one could help me with my problem and any advice on hooking up the hydraulics. The cylinder is single acting and about 42 inches long. Thanks in advance for any help that I might receive. Stan
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|