|
Tractor Talk Discussion Board |
Re: Re: Re: higher RPM or higher gear?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by HB on May 01, 2003 at 09:02:19 from (67.241.18.188):
In Reply to: Re: Re: higher RPM or higher gear? posted by Chet Glenn on May 01, 2003 at 06:01:49:
Do You seriously run that O-300 at full RPM -ALL THE TIME?
Or do you adjust the RPM to match what you are doing,i.e. takeoff power,cruise power,landing power?
No engine is designed to be run at full throttle for a great length of time.
Most Aircraft engines I've operated only allowed full takeoff power for up to 3 minutes and then a reduction to lower RPM/manifold pressure is required before damage occurs.
High RPM means shortened life for aircraft an engine or at least shortened TBO (time between overhaul).
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
