Tractor Talk Discussion Board |
Re: Building on to shop
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene Davis on May 01, 2003 at 20:15:31 from (66.82.9.28):
In Reply to: Building on to shop posted by Larry806 on May 01, 2003 at 19:48:44:
The best thing to do is to insulate every where you can. When I built mine the best things I added were, an air conditioned office space w/bathroom, with the top and walls insulated extra, and the top floored w/steps to use for storage space. A 4" pipe set in the concrete before pouring the floor, to put the 1/2' plate welding table w/vise on it, so when I get to hammering., or pulling on it, I don't have to chase the table down. Doors need to be at least 12' widex10' high, when backing trailer in it gives room to manuver. I also built mine with as a friend so aptly put it;"drag through capability", that means that there are doors right across from each other and you can pull some thing in and the tow vehicle can go right out the other door, sure makes it easier. I also sectioned off a "clean space" for working on small or delicate stuff like wife's furniture refinishing, also have air conditioner there for humidity/dust control. also have walk in doors on the other 2 walls that do not have large roll up doors in them, gives a chance at a breeze from all directions. The roof vent is nice to let the hot Georgia summer air out. Sky lights are bad news, read that; LEAK!!!!!!!!! Things I wish I had done. larger than 30'x75' the first 25' bay of the Butler building are a covered porch that has my twin post auto hoist on it, and a nice place to run up under to get out of vehicle when it's raining, but would like to have the other 23' for inside space also. This is my opinion only. Gene Davis
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|