Tractor Talk Discussion Board |
Re: tractor restoration
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F20II on May 05, 2003 at 08:54:42 from (208.187.14.109):
In Reply to: tractor restoration posted by anthony on May 04, 2003 at 11:07:05:
Like Don said, if you restore, (this means all new ) not repair (this mean fix an use ) you will not make any money. The tractor's I have restored have cost me over $2000 just in parts not counting tire's which add another $1000 to a restoration. So you buy a tractor for say $500 put $3000 in it, now you have $3500 an want to sell it for $4000, you may get lucky an sell it then again you may not. Now day alot of people are tryin to do this, this has driven up the price of the old iron to were profit is all but gone. The only place I see now days if you want to do this is in small tractors's Like a small Allis or Farmall Cub, A, or B, yeppie's are moving to the country, they want these type's of tractors to mow there lawns an plow thier gardens. So if you can fine one cheap, ( which is getting hard to do ) restore it not fix it up you might get a profit. Again like others have said, restoring is not putting plugs, points, rotor an cap on with a coat of paint an some decals, restoring is pulling everything apart down to the bare bone's replacing every seal, gasket, piston rings, pistons if needed, cap an rod bearings down to the grease zets. Then rebuilding the tractor from the ground up, priming, painting an polishing so it looks like it was just built yesterday. If you can make money doing that good luck I sure haven't. I do it because I love the history behind the equipment I restore, be it any tractor. Only my three cents :o)
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|