Tractor Talk Discussion Board |
Re: Mighty Mac skid steer parts?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on May 18, 2003 at 06:32:21 from (200.147.131.55):
In Reply to: Mighty Mac skid steer parts? posted by Brandon on May 16, 2003 at 09:28:14:
The Onan engine can be rebuilt, and parts are available, but pricey. They are a commonly used engine in lawn mowers, welders,and small industrial equipment. The pump parts could be had from the source you mentioned, or a good hydraulic repair shop. If they are hydrostatic pumps,it might be money well spent to have a hydro. shop check them out. The clearances are very small in them,and they may require lapping in,or other machine work which canīt usually be done without the proper equipment. Also be especially carefull about cleanliness when working on the Hydro.Cap all the lines and fittings. One small piece of sand or dirt can totally trash the pump or motors
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|